The switch will detect horizontal misalignment of belts when contact is made with the roller; the roller arm will be forced to pivot by the belt activating a switch at 15º to trigger an alarm, and 30º to trigger a shut down procedure of the conveyor. The sensors are usually installed in pairs on opposite sides of the belt.
A steel flexible wire is set below the running conveyor belt approx 20-30mm attached by a rare earth magnet at each end.
If the belt is ripped or damaged the wire is pulled away releasing the magnet connection which in turn will activate a switch.
The Bulldog is compatible with 4B’s CBS2 belt alignment monitor and the Watchdog Elite monitoring system. It has been approved for use in hazardous areas according to ATEX.